Monte Carlo Fan Company 5RDR - Manual (Page 3)

Install 3 screws to hold glass to fan
housing. Do not overtighten as this
could crack the glass.
10
Pull lead wires and safety cable out
from the yoke about 3”.
12
Lower upper glass disk onto fan housing and
align 3 holes in glass with 3 holes in fan hous-
ing.
9
Lift mounting neck to mounting Plate and align
screws.
7
Secure mounting neck to the mounting plate
with 6 screws to become a complete mounting
bracket.
8
Raise lead wire, safety cable, and
downrod up and align with slot for
pin in bottom of arch yoke. Push pin
into hole in downrod. After putting
in pin don’t twist downrod. Make
sure pin is fully engaged in slot.
14
Tighten set screws to hold downrod
securely in the arch yoke.
15
Place downrod into the arch yoke
and align the slot in arch yoke and
the hole in the downrod.
13
Place arms over the fan housing.
Make sure the arms with electrical
connection plugs are next to the
plugs on the fan housing.
17
Remove pin from downrod and save
for later step 14. Push the yoke
cover onto downrod. Thread lead
wires and safety cable through the
downrod.
11
Remove screw and nut on tab to
place arch arms in place. Save screw
and nut for use later step 19.
16
Close up for showing tab and screw
holes of fan body to place arch arms
over for arch installation.
18