Monte Carlo Fan Company 5RDR User Manual
Page 5
Lift Canopy to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
34
Attach blade brackets to blades using
the blade bracket screws and wash-
ers provided.
35
Install all 5 fan blade assemblies to
the motor as shown above. Tighten
screws securely.
36
For Canadian installation in both flush and
downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
31
Canadian mounting only
Safety Cable
Lag Screw
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
33
white
black
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Orange from fan to Orange from remote
marked Light/up. Blue from fan to blue from
remote marked down light. Black from fan to
Black from remote marked L. White from
house to white from remote marked AC N .
Black from house to Black from remote
marked AC L. Connect all green ground wires
to Ground wire from House.
orange
blue
Green
white
black
House
Fan
32
Loosen 2 screws and remove one
and save it. Place plate’s key slotted
holes over the 2 screws loosened and
twist into place. Replace removed
screws and tighten all 3.
37
Attach switch housing to fan using
the three screws provided.
39
Plug 9 pin wire connections together.
38
Remove cover by snaping off from
top or bottom. Install 12V battery
into wall remote. Duracell MN21 /
Eveready A23 / GP 23A all 12V.
40
Install wall control unit to outlet box
using machine screws provided.
42
Attach cover of remote by placing
over buttons and snaping into place.
41