Meyer Sound HMS-10TM - Manual (Page 19)

19
APPENDIX B: HMS-10 CABLE ASSEMBLY
CAUTION: When wiring HMS-10 loudspeaker cables, it is extremely important that each pin be wired correctly.
Make sure the 48 V DC from the external power supply is wired directly (and only) to the 48 V DC pins on the
HMS-10 loudspeaker connector, and that the polarity is observed (negative to negative, positive to positive) to avoid
damage to the loudspeaker. In addition, make sure that audio pins are wired correctly; polarity reversals for audio sig-
nals affect system performance.
ASSEMBLING PHOENIX-TO-PHOENIX LOUDSPEAKER CABLES
To connect the HMS-10 loudspeaker directly to the MPS-488HPp power supply, you need a Phoenix 5-pin female to
Phoenix 5-pin female cable. The following procedure documents how to assemble this cable.
To assemble a Phoenix-to-Phoenix cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding 1 inch and then strip the black,
red, blue, and white wires .275 inch.
2. Insert the five exposed conductors, from one end of the cable, into the five cable holes in one of the Phoenix connectors.
Use the following wiring scheme.
Assembled Phoenix-to-Phoenix Cable
Phoenix 5-Pin Female Cable Mount Connector
!
1”
0.275”
Pin #1 Black 48 V DC (–)
Pin #2 Red 48 V DC (+)
Pin #3 Shield Audio shield
Pin #4 Blue Audio (–)
Pin #5 White Audio (+)
Connector side up Side (cable attached)