Removing the hinge support l and mp hold plate, Removing the battery connector ass’y, Removing the sc relay pcb and hdd hold plate – Matsushita CF-52AJYZDZM User Manual
Page 33: Removing the heat sink ass’y
9-10
9.1.23.
Removing the Hinge Support L and
MP Hold Plate
1. Peel off the three Tapes and remove the two Cables(Gray
and Blue).
2. Remove the six Screws <N4>, remove the Hinge Support
L and MP Hold Plate.
Screw <N4> : DRHM0093ZA
9.1.24.
Removing the Battery Connector
Ass’y
1. Remove the two Screws <N2> and <N4>, and remove
the Battery Connector Ass’y.
2. Remove the two Screws <N6>, and remove the Batt FPC
Plate.
3. Remove the two Screws <N5>, and remove the Batt Con
Holder from the FPC Batt.
Screw <N2> : DFHE5122YA
Screw <N4> : DRHM0093ZA
Screw <N5> : DRHM0112ZA
Screw <N6> : DRHM0115ZA
9.1.25.
Removing the SC RELAY PCB and
HDD Hold Plate
1. Disconnect the FFC from the Connector(CN6503).
2. Remove the two Screws <N2>, and remove the SC
RELAY PCB.
3. Remove the two Screws <N4>, and remove the HDD
Hold Plate.
Screw <N2> : DFHE5122YA
Screw <N4> : DRHM0093ZA
9.1.26.
Removing the Heat Sink Ass’y
1. Remove the Fan Duct.
2. Remove the four Screws <K138>, and remove the Heat
Sink Ass’y.
Screw <K138> : DRHM0119ZAT
<N4>
Cables
(Gray and
Blue)
<N4>
<N4>
Tapes
<N4>
<N4>
Hinge
support L
MP hold
plate
<N4>
<N4>
<N4>
Batt FPC plate
Batt con holder
<N6>
<N2>
<N5>
FPC batt
<N2>
<N4>
CN6503
<N4>
SC RELAY PCB
HDD hold plate
FFC
Tape
<K138>
Fan duct
<K138>
Heat sink
ass'y