Marantz CC3000 - Manual (Page 14)

Note:
– Repeating of a CD is not possible during shuffle or
program mode.
Repeating all CDs:
• Press REPEAT three times before or during playback.
– REPEAT lights up; all CDs will now be repeated
continuously.
• Press REPEAT again to stop the CDs being repeated.
NOTE!
– When a program has been stored (for one or more
CDs), then only the program will be repeated.
Searching For The Loudest Passage
(PEAK SEARCH)
• In STOP mode, press PEAK SEARCH.
–
lights up and PEAK starts flashing.
• Press PEAK SEARCH again to select the last
selected disc or press any CD DIRECT PLAY button
or DISC (on the remote control) to select the desired
disc.
– The CD will now be scanned for the loudest passage
(the peak).
– The display shows the track being scanned and its
elapse playing time.
– When the loudest passage has been found it will be
repeated continuously (from 2 seconds before the
peak until 2 seconds after the peak) and PEAK lights
up.
• You can now adjust your recording device.
• You can stop the scan by pressing STOP
9: if you
press PLAY 2, the CD will be played from the
beginning.
NOTES!
– When searching for the loudest passage in a program
(from one or more CDs) there is no need to enter the
CD number(s).
– If you wish to record tracks from different CDs you
have to repeat peak search for each CD.
– You can interrupt PEAK SEARCH by pressing STOP 9.
Adjusting The Sound Level
(- VOLUME +)
(on the remote control only)
The volume output of the CD changer can be adjusted.
This will affects the analog out, digital out and
heaphones level.
• Press VOLUME - or + to reduce or increase the
sound level.
– The display will show a value between VOL 0 and
VOL 20.
Important!
The volume level will influenced the sound level
during recording. Set the volume level to the
maximum and do not change the volume setting
during recording.
Locking the volume
This unique feature allows you to lock the volume level
when listening to the heaphones or doing recording.
• Press EDIT for more than 2 seconds.
– The displays will show VOL LOCK.
Unlocking the volume
• Press EDIT for more than 2 seconds.
– The displays will show VOL 20.
Note:
– When you adjust the volume and the display shows
VOL LOCK, it means that the volume is in the lock
mode.
Listening to the heaphones
• Connect the headphones to the PHONES socket.
• Adjust the headphones sound level with the LEVEL
control.
Note:
– Should there be no sound after adjusting the LEVEL
control to maximum; press VOLUME + on the remote
control to increase the sound level.
14
English
PLAYBACK