Motorola Communications Gateway - Manual (Page 17)

12 Communications Gateway User Guide
X
Home Print Exit
Introduction Before You Begin Installation & Configuration FAQ Troubleshooting Glossary License
Installation and Configuration Overview
To install and configure your Motorola Communications Gateway, you need to:
1 Install the cables as described in one of:
■ “Cabling and Startup for a Single User” on page 13
■ “Cabling for Multiple Users” on page 43
2 If you are using the USB Connection , set up the USB driver. Follow the instructions
in “Setting Up a USB Driver” on page 21. Ethernet users can skip this step.
3 Configure TCP/IP following the instructions in “Configuring TCP/IP” on page 32 or
the instructions in your Macintosh or UNIX user manual.
4 Verify the IP address following one of:
■ “Verifying the IP Address in Windows 95, 98, or Me” on page 40
■ “Verifying the IP Address in Windows 2000 or XP” on page 41
■ The instructions in your Macintosh or UNIX user manual