Motorola Communications Gateway - Manual (Page 57)

52 Communications Gateway User Guide
Wall Mounting, continued
Introduction Before You Begin Installation & Configuration FAQ Troubleshooting Glossary License
X
Home Print Exit
6 If necessary, seat an anchor in each hole.
Use M5 x 38 mm (#10-16 x 1 1 /
2
inch) screws with a flat underside and maximum
screw head diameter of 10.5 mm to mount the Communications Gateway.
7 Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown
at left:
■ There must be 4.0 mm between the wall and the underside of the screw head.
■ The maximum distance from the wall to the top of the screw head is 7.6 mm.
8 Place the Communications Gateway so the keyholes are above the mounting
screws.
9 Slide the Communications Gateway down so it stops against the top of the keyhole
opening.
7.6 mm maximum
10.5 mm maximum
4.0 mm