METRObility Optical Systems R380-SS - Manual (Page 24)

24 User Guide
Changing the SFP Optics
The multi-rate line card supports two replaceable small form-factor pluggable
(SFP) transceivers. This section explains how to remove and install the optics on
the card. Metrobility SFP transceivers are hot-swappable.
IMPORTANT: Use only Metrobility-supplied SFP transceivers with this
product. Installing any other optics may damage the unit and will void the
product’s warranty.
1. Disconnect the fiber optic network cables, if they are installed, from both
the receiver (RX) and transmitter (TX) of the SFP transceiver.
WARNING: Avoid looking into the laser or cable.
2. To remove the SFP optics from the multi-rate line card, simply pull open the
release mechanism (i.e., plastic tab, release wire, etc.) and slide the module
out of the slot, as shown below, left.
100 BASE
redundant twister “
MAIN
RESET
LK
AT
PRIMARY
LK
AT
SECONDARY
LK
AT
R
X
T
X
R
X
T
X
PWR
SW
MULTIRATE
1
2
SD
BP
PWR PWR
1000 BASE
M
A
I
N
P
R
I
S
E
C
AT
LK
AT
LK
AT
PWR
SW SEC
LK
RESET
1
2
LB
SD
BP
LB
SD
BP
LB
SD
BP
LB
MULTIRATE MULTIRATE
1
2
SD
BP
PWR
LB
SD
BP
LB
MULTIRATE
1
2
SD
BP
PWR
LB
SD
BP
LB
MULTIRATE
1
2
SD
BP
PWR
LB
SD
BP
LB
CIRCUIT
BOARD
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
BWDM SFP
RELEASE
MEHCANISM
RX
TX
3. Align the new SFP module so the receiver (▲) is positioned above the
transmitter (▼). For a BWDM SFP, align it so the visible part of the circuit
board located at the back of the module is to the right.
4. Keeping the release mechanism in the closed position (bail latch should be
locked in place), slide the new SFP into the slot and push it firmly in place.
5. Remove the protective dust cover on the LC or SC connector.
6. Reconnect the network cables. Verify proper segment connectivity via the
green LK LED, which will be lit.