Multi-Tech Systems MT128ISA-UV - Manual (Page 19)

19
Chapter 2 - Installation
MT128ISA/PCI
13. Add your second NDISWAN ISDN device by clicking Add and selecting ISDN-2-
IINWANNT from the list box. Click OK to add this device to the RAS Setup as shown in
figure 2-8.
Figure 2-8. Remote Access Services (RAS) Setup
14. Select the ISDN1 and click Configure to setup Port Usage for this ISDN1port. Depending
upon your use of this channel, select Dial out only, Receive calls only, or Dial out and
Receive calls. Click OK.
Figure 2-9. Configure Port Usage Installation
15. If you choose Dial out only, click OK, and then click the Network tab. Select the protocol
you will use. If you are going to access the Internet, choose TCP/IP.
Figure 2-10. Configure Dial Out Protocol
16. If you Select Receive calls, or Dial out and Receive calls, click OK, then click the Network