Marantz SR7002 - Manual (Page 19)

SR8002/SR7002
RS-232C Control Specification
Page: 19 / 32
Document Version [1.00]
Company Restricted
5-2. Status request and Status answer list
5-2-1. Normal Status request and Status (answer and feedback) list
Status request Status answer and feedback
OFF “PWR:1”
POWER “PWR:?”
ON “PWR:2”
OFF “ATT:1”
AUDIO ATT “ATT:?”
ON “ATT:2”
OFF “AMT:1”
AUDIO MUTE “AMT:?”
ON “AMT:2”
OFF “VMT:1”
VIDEO MUTE “VMT:?”
ON “VMT:2”
VOLUME “VOL:?”
Volume value = xxxy
(see command list) “VOL:xxxy”
(+18.0 ~ -80.0dB)
TONE BASS “TOB:?”
Bass value = xxx
(see command list)
“TOB:xxx”
TONE TREBLE “TOT:?”
Treble value = xxx
(see Command List)
“TOT:xxx”
SOURCE Select “SRC:?”
Video+Audio source
(see Command List)
“SRC:va”
(v ,a= ‘0’ ~ ‘Z’)
(v = video, a = audio.)
OFF “71C:1”
7.1 Channel Input “71C:?”
ON “71C:2”
ANALOG “INP:1”
DIGITAL “INP:2”
HDMI “INP:4”
AUTO[DIGITAL] “INP:6”
INPUT (A/D) SELECT “INP:?”
AUTO [HDMI] “INP:8”
ANALOG “ISG:1”
DIGITAL “ISG:2”
INPUT SIGNAL “ISG:?”
HDMI “ISG:4”
SPEAKER Select “SPK:?”
Speaker status = ab
a = SPKR-A, b = SPKR-B “SPK:ab”
a,b (1 = OFF, 2 = ON)
HDMI OUT CH1 “HDM:1”
HDMI OUT CHANNEL “HDM:?”
HDMI OUT CH2 “HDM:2”
HDMI ENABLE “HAM:1”
HDMI AUDIO MODE “HAM:?”
HDMI THROUGH “HAM:2”
UNKNOWN “IST:0”
OFF “IST:1”
Source Input State “IST:?”
ON “IST:2”
AUTO LIP SYNC DISABLE
“ALS:1”
AUTO LIP SYNC “HAL:?”
AUTO LIP SYNC ENABLE “ALS:2”
I/P CONVERT DISABLE “IPC:1”
IP CONVERTER “IPC:?”
I/P CONVERT ENABLE “IPC:2”
COMP2 MAIN ROOM “CM2:1” COMPONENT2 SELECT
This command is available
for SR8002 only. “CM2:?”
COMP2 MULTI ROOM “CM2:2”