Master Appliance 1425-3550 FPM130-900F - Manual (Page 4)

clothes. W ash hair and
body thoroughly with soap
and water.
12. W ARNING: T o reduce the
risk of fire or electric shock,
do not expose heat guns to
rain or moisture. Store
indoors. Connect to
grounded outlet only.
13. Do not use plug adapters or
remove the ground prong
from the plug. This tool is
equipped with a 3-prong
plug and a 3-wire grounding
system. Connect to properly
grounded outlets only.
14. Use heat gun only on
adequately rated circuits to
avoid overheating of
electrical systems.
15. Proheat heat guns can
produce up to 1050°F of
flameless heat out of the
nozzle. Do not direct this hot
air stream at your clothing,
hands or body parts. Do not
use as a hair dryer.
16. Do not touch nozzle
opening or nozzle shield
until cool. When in “Hot”
mode, extreme heat is
generated at those areas.
Always hold tool by the
handle or use permanently
attached stand.
17. Run on cool before turning
off. The nozzle and shield
require approximately 3
minutes to become cool to
the touch. Stand the unit on
its end with the nozzle
pointing upward after turning
off.
18. Do not touch work surface
with nozzle. Scrape paint
4
Important Safety Instructions
(cont’d)
with nozzle face at least 1”
away.
19. Keep a clean work area.
Messy or cluttered work
areas invite accidents or
injury.
20. Keep away from children. All
visitors should be kept at a
safe distance from the work
area. Do not let visitors
touch the tool or extension
cord.
21. Use tool in a well-ventilated
area. Do not use near
flammable liquids or in an
explosive environment
(where fumes, gases or dust
are present).
22. Remove all highly flammable
materials and other debris
from the work area.
23. Wear safety glasses at all
times.
24. When using an extension
cord, use only a 3-wire
grounded cord with a
minimum of 14-gauge
capacity. We recommend
they be listed by Under-
writers Laboratories (UL) in
the U.S.A. or (CSA)
Canadian Standards
Association in Canada and
be suitable for outdoor use.
Cords marked for outdoor
use are also suitable for
indoor use.
25. Don’t abuse cordset. Never
pull by cord to remove from
electrical outlet or carry tool
by cord.
26. When not hand-held, place
tool on a level surface.
Position cordset so it does
Save These Instructions.
not cause tipping.
27. Keep a fully-charged fire
extinguisher close at hand.
28. Do not leave heat gun
unattended while it is
running or cooling down.
29. Stay alert. Do not operate
tool when you are tired. Use
common sense and watch
what you are doing.
30. Store properly. Do not store
while hot. Store in a dry,
high or locked-up location.
Keep out of the reach of
children.
31. Always unplug tool before
performing any
maintenance. When
servicing, use only Master
Appliance brand
replacement parts. We
recommend that all
maintenance be performed
by a qualified repair
technician who is
experienced in the repair of
electric tools, a qualified
service organization, or our
repair staff.For Factory
Repair Service, send
product to:
32. WARNING: This product
when used for soldering
and similar applications,
produces chemicals
known to the State of
California to cause cancer
and birth defects or other
reproductive harm.
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403