Master Appliance 1425-3550 FPM130-900F - Manual (Page 7)

Repairs:
This unit is not user
servicable. The unit must be
returned to the factory for
prompt repair and calibration.
This gun is equipped with a
temperature cutout device
intended to shut off power to
the gun if set internal
temperatures are exceeded. If
gun doesn’t function, please
refer to our warranty repair
page in this booklet for
additional information.
Please refer to our warranty
repair page in this booklet
(p8) for additional
information.
Note:
Always unplug your tool
before cleaning.
Heating Elements:
Heating element abuse and
eventual burnout can occur
from one of the following
conditions:
1) Improper line voltage
2) Improper attachment
3) Nozzle too close to work
being heated (less than
1 inch).
Lubrication
Bearings are lubricated at
tfactory and require no further
lubrication.
Cleaning:
Unplug heat gun before
cleaning. To clean outside of
tool, use only a mild soap and
damp cloth. Do not use other
cleaning agents, turpentine,
gasoline, lacquer or paint
thinner, or other solvents that
may contain chemicals which
are harmful to plastics and
other insulating materials.
Never immerse tool in a liquid
or allow a liquid to enter inside
the tool. Make sure all vents
and openings are free and
clear of debris.
Maintenance Instructions
Accessories/Attachments
7
Users should independently evaluate the
suitability of the product for their application.
35016
Spreader attachment
35017
Heat shrink attachment
35026
Nozzle Shield
35289
Raychem mini-gun adapter
35292
Specalty connector
attachment
35293
9/16” reducer
35294
5/16” reducer
35216
bench stand
35309
Attachment Kit
5 of our most popular
application tips