MITSUBISHI ELECTRIC WD-52527 - Manual (Page 75)

75
Chapter 5. TV Menu Screen Operations
Audio/Video
Figure 24
A/V Memory Reset
A/V Memory Reset allows you to select the device/input
which will have the A/V Settings returned to the original
factory settings. To return a device’s memory to the
original factory settings, select the device and then press
ENTER.
Settings
Each device has its own A/V memory. Select the device
in A/V Memory Reset, then select Audio or Video to
adjust the device’s individual settings. Press ENTER,
and the menu is removed and the individual settings are
displayed.
Use ADJUST or to cycle through the individual
settings to be adjusted. Use ADJUST or to make
the adjustment. For descriptions of the individual A/V
settings see A/V Setting Descriptions, pages 76 and 77.
Video Mute
Video Mute lets you display a blue background when no
signal is being received on Inputs 1-3, or Components 1-3.
Film Mode
Auto is the default setting and will automatically detect
and apply film decoding correction for signals that
originated on 24 frames per second film cameras and
then were converted for broadcast to 30 frames per
second video.
When the original signals originated on 30 frames per
second video cameras, the Auto setting will automatically
apply video decoding, the same as used with the Off
setting. Try the Off setting when the TV seems to have
difficulties and adds too many jagged edges to the
images.
Film Mode does not apply to high definition or 480i signals.
Audio/Video Menu
Figure 24. Audio/Video Menu, Settings
Using the AUDIO or VIDEO Button on the Remote
Control
To adjust individual Audio or Video settings directly with
the remote control:
1. Press AUDIO or VIDEO to cycle through the available
settings.
2. Press ADJUST or to adjust the setting. After 5
seconds of inactivity, the setting display will disappear.
TV Speakers
This selection will turn on or off the TV’s internal
speakers. You may select Off when sending the sound
through a separate stereo system or surround sound A/V
receiver. When NetCommand
®
is enabled, selecting
the A/V receiver icon from the Device Selection menu
automatically turns Off the TV speakers. See the
NetCommand information for further instructions.
Note: To prevent damage from a sudden increase in
the volume level, make sure the TV volume is set to low
before setting speakers to On.