MITSUBISHI ELECTRIC WD-52631 - Manual (Page 15)

Chapter 1. Television Overview 15
Lift cover to use
the control panel
and INPUT 3 front
A/V jacks.
TV Front Panel
A/V Reset
If you wish to reset the A/V (Audio/Video) settings back to
the factory defaults:
• To reset all settings at once, press
GUIDE and FORMAT on
the front panel at the same time.
• To reset the defaults for individual devices, use the
A/V Memory Reset selection on the Audio/Video
menu.
Above and Below:
1. Shaded buttons are duplicates of keys on the
remote control
2. POWER/TIMER indicator—lit during normal
operation; flashing when auto-on TV Timer is set
3. LAMP indicator shows lamp condition (usually off
during normal TV operation)
4. STATUS indicator (off during normal TV opera-
tion)
5. SYSTEM RESET (see description this page)
Control Panel
The shaded buttons on the front control panel duplicate
keys on the remote control. The upper labels show control
functions when no TV menus are displayed; the lower
labels indicate functions when TV menus are displayed or
when a special function has been activated. See “Remote
Control Overview” in chapter 3, “TV Operation,” for further
details on the functions of these buttons.
Model WD-52631
1
5
System Reset Button
If the TV does not respond to the
remote control, front panel controls,
or will not power on/off, press the
SYSTEM RESET button on the front panel
with a pointed object, such as the point
of a pencil or end tip of a paperclip.
The green LED will flash quickly for
about one minute. When the green LED stops flashing,
you may turn on the TV.
4:45&.


3&4&5
Models WD-57731
and WD-65731
1 4 3 1 5 2
INPUT 3 and controls on front panel of WD-57731 and WD-65731
Input 3
INPUT 3 provides an easily accessible set of standard
audio/video jacks. These jacks allow for convenient con-
nection of a camcorder or other audio/video device. Note
that if you connect to the
S-VIDEO jack, the VIDEO jack
is deactivated.
Model WD-52631
2 3 4 1