MTD OEM-190-627 User Manual
Page 5
5
SECTION 2: TO THE OWNER
Model 627 42-inch two-stage snow thrower is designed for use on 600-series lawn tractors manufactured in
1996 or later ONLY. It will NOT fit nor operate properly or safely on ANY other tractor. It will NOT fit on any
FastAttach™ compatible tractor.
NOTE: If your 600-series lawn tractor was manufactured prior to 1996, model 627 snow thrower attachment can be
mounted on the tractor with special instructions and minor modifications to the tractor. Phone our Customer Support
Department as instructed on page 2 for details.
NOTE: References to LEFT and RIGHT indicate the left and right sides of the tractor when facing forward in the
operator’s position. Reference to the FRONT indicates the grille end; to the REAR the drawbar end.
SECTION 3: CONTENTS OF CARTON
Before beginning installation, remove all parts from the carton to make sure everything is present. Carton contents
are listed below and shown in Figure 3. Part numbers are shown in parentheses.
•
One Auger Housing Assembly
•
One Undercarriage Assembly with
Upper V-belt (754-0449) & Lower V-belt (754-0330)
•
One Support Carriage Assembly
•
One Chute Directional Control with Tilt Lever
•
One Lift Handle Assembly with Cable
•
One Upper Chute Crank Rod
•
Two Self-adhesive Reflectors (730-3000)
•
Three Cable Ties (725-0157)
•
One Extension Spring (732-0626)
•
Two Spare Shear Bolts (710-0890A)
& Hex Lock Nuts (712-0429)
•
One Flat Washer (736-3019)
•
One Hairpin Clip (714-0145)
•
Two Hex Screws (710-0376)
•
Two Belleville Washers (736-0242)
•
Two Lock Washers (736-0119)
•
Two Hex Nuts (712-3010)
•
Two 1¼-inch Cotter Pins (714-0470)
•
One ¾-inch Cotter Pin (714-0507)
Figure 3
Chute Directional Control
Undercarriage Assembly
Auger Housing Assembly
Lift Handle Assembly
Self-adhesive
Cable
Spare Shear Bolts
Upper Chute Crank Rod
Support Carriage Assembly
Extension
¾-inch
1¼ Cotter Pins
Hex Screws,
Reflectors
Spring
Ties
Belleville Washers,
Lock Washers
and Hex Nuts
Cotter Pin
& Hex Lock Nuts
Flat Washer
& Hairpin Clip
with Upper V-belt & Lower V-belt
with Tilt Lever
With Cable