MTD Squall 521 - Manual (Page 12)

Replacing Belt
Remove the belt cover by removing five hex screws which
secure it. See Figure 7-1.
Remove the belt by grasping it from the bottom of the
auger pulley and pull outward.
NOTE: Push down on the idler pulley to release the belt
from under the belt keeper. See Figure 7-1.
1.
2.
To install the replacement belt, procede as follows. Refer to
Figure 7-2:
Push down on the Idler pulley.
Position the belt on top of the auger pulley, under the belt
keeper.
Route the belt around the engine pulley.
Push the belt over the bottom of the auger pulley.
Reinstall the belt cover removed earlier.
1.
2.
3.
4.
5.
Belt Keeper
Idler pulley
Figure -1
Auger Pulley
Engine Pulley
Figure -2
Service
7
12