MTD Squall 521 - Manual (Page 9)

Auger Control Handle
Located on the upper handle, the auger control handle is used
to engage and disengage drive to the auger. Squeeze the control
handle against the upper handle to engage auger; release it to
disengage.
Chute Assembly
Rotate the chute assembly to the left or right using chute
handle. Pitch of the chute assembly controls angle at
which the snow is thrown. Loosen wing knob on side of the
chute assembly before pivoting chute assembly upward or
downward. Retighten the knob once desired position has
been achieved.
Shave Plate
The shave plate maintains contact with pavement as the snow
thrower is propelled, allowing snow close to pavement’s surface
to be discharged.
Gasoline Cap
Remove gas cap to add fuel.
Oil Fill
Remove cap to add oil. Refer to engine owner’s manual packed
with this unit for instructions on adding oil.
9 s
ectiOn
4 — c
OntrOls and
f
eatures