Metrologic Instruments StratosH MS2321 - Manual (Page 41)

37
S CANNER O PERATION
B EEPER O PTIONS AND B UTTON F UNCTIONS
Changing the Beeper Tone
Beeper tones may be configured incrementally using the following bar code. The new tone will be heard followed by a short
pause. Two more new tones will be heard signifying the new setting has been stored in memory. The silent (no beep) tone is
also selectable.
³ 9 9 9 9 7 5
Next Beep Tone
Changing the Beeper Volume
Volume levels may be configured using the volume button or incrementally using the following bar code. The new volume will
be heard followed by a short pause. Two more tones will be heard signifying the new setting has been saved in memory.
The silent (no volume) tone is also selectable.
³ 9 9 9 9 7 4
Next Volume
The Multi-Function Button
Figure 36. The Multi-Function Volume Button
Changing the Beeper Volume
A
short (<3 second) depression and the beeper volume will change.
The new volume will be heard. The silent (no beep) volume is also selectable.
Placing the Unit in Laser & Motor Off Power Save Mode
Long (>3 seconds) depression The Laser & Motor Off Power Save Mode is the only
power save mode that can be activated with the multi-function button*.
*
This feature is configuration dependent. Refer to the MetroSelect Configuration Guide
(
MLPN 00-02407x) under Scanner Operation: Power Save Modes to enable this feature.
Waking the Unit from All Power Save Modes
The next button depression will awaken the scanner for normal operation.
Figure 37. Changing the Beeper Volume
Figure 38. Laser & Motor Off
Power Save Move
Figure 39. Normal Operation