Multi-Tech Systems MT5634ZLXFE User Manual
Page 19
Chapter 4 – AT Commands, S-Registers, and Result Codes
MT5634ZLX, MT5634ZLXI, MT5634ZLX/FE User Guide
19
Command
Options
Function & Description
&P0 (default)
Make=40%, Break=60% for use in North America.
&P1
Make=33%, Break=67% for International use.
&Rn
CTS/RTS option (for non-CTS flow control mode and synchronous mode
only).
&R0 (default)
CTS follows RTS.
&R1
CTS always true.
&Sn
Data Set Ready (DSR) option.
&S0 (default)
DSR always on.
&S1
DSR on during handshake and on-line, off in test mode or idle mode.
&Tn
Self-test commands.
&T0 (then ^ATO)
Terminate test.
&T1
Local analog loopback test.
&T3
Local activated remote digital loopback (RDL) test.
&Vn
View active configuration and stored profile.
&V0
View active file, stored profile #0 and stored phone numbers.
&Wn
Store active profile.
&W0
Save active configuration as user profile #0.
&W1
Save active configuration as user profile #1.
&Yn
Select stored profile on power-up.
&Y0
Recall user profile 0 on power-up.
&Zn=x
Store telephone number n=0 to 3.
x=<string>
See also the dial modifier in ”ATDn” command. The maximum number of
digits per string is 36.
%A
Adaptive Answer Result Code Enable.
%Cn
Data compression option.
%C0
No compression.
%C1 (default)
MNP 5 compression.
\Gn
Set modem port flow control.
\G0 (default)
Disable port flow control.
\G1
Set port flow control to XON/XOFF.
\Jn
Constant DTE speed option.
\J0 (default)
DCE and DTE rates are independent.
\J1
DTE rate adjusts to DCE connection rate after on-line.