Multi-Tech Systems MT5634ZLXFE - Manual (Page 25)

Chapter 4 – AT Commands, S-Registers, and Result Codes
MT5634ZLX, MT5634ZLXI, MT5634ZLX/FE User Guide 25
Terse Verbose Description
80 * CONNECT 52000 Connected at 52000 bps
81 * CONNECT 54000 Connected at 54000 bps
82 * CONNECT 56000 Connected at 56000 bps
88 DELAYED Delay is in effect for the dialed number
89 BLACKLISTED Dialed number is blacklisted
90 BLACKLIST FULL Blacklist is full
100 CONNECT 28000 Connected at 28000 bps, V.90 rate
101 CONNECT 29333 Connected at 29333 bps, V.90 rate
102 CONNECT 30666 Connected at 30666 bps, V.90 rate
103 CONNECT 33333 Connected at 33333 bps, V.90 rate
104 CONNECT 34666 Connected at 34666 bps, V.90 rate
105 CONNECT 37333 Connected at 37333 bps, V.90 rate
106 CONNECT 38666 Connected at 38666 bps, V.90 rate
107 CONNECT 41333 Connected at 41333 bps, V.90 rate
108 CONNECT 42666 Connected at 42666 bps, V.90 rate
109 CONNECT 45333 Connected at 45333 bps, V.90 rate
110 CONNECT 46666 Connected at 46666 bps, V.90 rate
111 CONNECT 49333 Connected at 49333 bps, V.90 rate
112 CONNECT 50666 Connected at 50666 bps, V.90 rate
113 CONNECT 53333 Connected at 53333 bps, V.90 rate
114 CONNECT 54666 Connected at 54666 bps, V.90 rate
* EC is added to these Result Codes when the extended Result Codes configuration option is enabled. EC is replaced
by one of the following codes, depending on the type of error control connection: V42bis (V.42 error control [LAP-M]
and V.42bis data compression); V42 (V.42 error control [LAP-M] only); MNP5 (MNP 4 error control and MNP 5 data
compression); MNP4 (MNP 4 error control only); NoEC (No error control protocol).