Memorex MX9790 - Manual (Page 3)

LOCATION OF CONTROLS CONNECTING THE LOUDSPEAKERS
Connect the cables of the two loudspeakers to the corresponding input (R) for the
right speaker and input (L) for the left speaker, located at the back of the unit.
Warning:
z Connect the loudspeakers before powering the unit:
z The unit may not work properly or get damaged if you use speakers
different than the ones supplied with the unit
AC OPERATION
Connect the plug to the AC socket of the unit and the other end to a standard AC
outlet.
ATTENTION
1. Do not plug or unplug the power cable while you have wet hands;
2. When planning not to use this unit for a long time, disconnect the power
cable from the wall outlet;
3. When disconnecting the power cord from the wall outlet, do not pull on the
cord in order to avoid shock risks caused by damaged cable.
1. Speakers 16. Minute Set Button
2. Function Switch 17. Repeat Button
3. Power Switch 18. Play/Pause Button
4. Stereo Headphones Jack 19. FM Stereo Indicator
5. Volume Control Knob 20. Stop Button
6. Skip / Backward Search Button 21. CD Door
7. Remote Sensor 22. Tuning Knob
8. Skip / Forward Search Button 23. CD Door Open Button
9. Power Indicator 24. CD Door Close
10. Program Button 25. Band Switch
11. ON / OFF Alarm Switch 26. AC Socket
12. Display
(CD, Time, AM/FM Station, Alarm)
27. Left Speaker Jack
13. Alarm Set Button 28. Right Speaker Jack
14. Time Set Button 29. FM Wire Antenna
15. Hour Set Button
SET THE CORRECT TIME
Before starting to set the time, make sure that the Function Switch is not on Radio
position.
Press and hold the time button as well as the Hour and Minute buttons simultaneously,
in order to set the time. Release all buttons when reaching the correct time.
RADIO OPERATION
1. Set the Function Selector to Radio position;
2. Set the band selector to AM/FM position;
3. Adjust the TUNING control to tune in a radio station.
SET THE ALARM TIME
Before starting to set the alarm time, make sure that the Function Switch is not on
Radio position.
Press and hold simultaneously the Alarm button as well as the Hour and Minute
buttons, to adjust the alarm time. Release all buttons when reaching the desired alarm
time and the display will go back to regular time.
- 3 - - 4 -