Magellan All-In-One Security System V1.0 MG-6060 - Manual (Page 21)

Paradox Magellan Systems 19
Figure 20: Remote Control Button Options
* = Hexa values A to F are keys [1] to [6] from Magellan’s Center
Keypad.
†
= The panic feature (section [091] options [1] to [3]; see
page 23) must be enabled in order for this to work.
Figure 21: Replacing the Remote Control’s Battery
Hexa
Value
Description
Hexa
Value
Description
0 Button disabled 8 Panic 1 †
1 Regular arming 9
Panic 2 †
2 Stay arming A* Panic 3 †
3 Instant arming B* PGM Activation (Event Group #07 - Refer to the Magellan Programming Guide)
4 Force arming C* PGM Activation (Event Group #08 - Refer to the Magellan Programming Guide)
5 Future use D* Turn FM radio ON/OFF
6 Future use E* FM radio memory scan
7 Future use F* Paramedic alarm
Inset 1: Removing the Battery Inset 2: Inserting the New Battery
Step 1
Step 2
WARNING!
Damage to the metal prongs may
occur if the battery is not inserted
correctly.
Battery type: One 3V lithium battery (CR2032)
How to replace the battery:
1. Remove the two screws from the back of the remote control and remove the back cover.
2. Slide a teflon screwdriver, or any plastic device, under the battery to remove it from the battery compartment (see Inset 1 below).
Avoid using metal as it may cause a short in the board.
3. Insert the new battery as shown in Inset 2 below. The negative side of the battery is inserted face down.
4. Set the back cover in place and fasten it with the two screws.