Maytag Washers & Dryers - Manual (Page 3)

4.
know your dimensions
measure now
,
not later
No one wants to bring home a washer that won’t fit
where it belongs or a gas dryer that can’t be connected.
Make sure you take the following steps to ensure your
purchase process goes smoothly.
d
o
i
t
y
ourself
:
• decide where you will install your new
washer and dryer.
You will need:
o a level floor with no more than a 1” slope
o A location that can support the installation
of a dryer exhaust system
o Hot and cold water lines within 3’ of
washer hookups
• Measure the height, width & depth of the area
designated for your new washer and dryer.
• Measure the clearance of doorways,
hallways and other points of entry that will
be used to deliver your new laundry pair.
• Confirm that electrical output is sufficient for the
location of your new washer and dryer.
You will need:
o a grounded electrical outlet within 4’ of
the rear of both machines (no extension
cord or adaptor)
o A separate designated 30-amp circuit
• Set water heater to 120º for washer.
• Contact licensed gas or heating professional
if you plan on purchasing a gas dryer.
Your home should have:
o A CST International approved gas supply line
o A shut-off valve
• decide how you will dispose of your old
laundry pair, if necessary.
o Some retailers offer removal of your old
machines when your new ones are delivered
o Washers and dryers in good condition may
be donated to a local charity
W
H
W
H
D
know before you go PaGE 3 OF 3
p hone i t i n :
The following tasks should not be attempted
without the help of an appropriate professional if
you lack the experience or tools to do it alone.
Here’s how to measure:
W: side to side
(add 1” on each side for
air circulation)
D: back to front
(add at least 6” to depth for door
clearance, dryer vents, and hookups)
H: top to bottom
(for top-loading washers, add
at least 20” for door clearance)