Maytag MAH-24 - Manual (Page 7)

6
Select Cycle Options
Press the pads to select one or more options.
Extra Rinse
Adds an additional rinse at the end of the cycle to
more thoroughly remove laundry additives and
perfumes.
Chime
Press the Chime pad to activate audio Power on, start
and end-of-cycle signals.
Delay Start
Any cycle can be delayed for up to 19 hours in one
hour increments.
1. Make the appropriate selections for your load.
2. Press the Delay Start pad until the desired delay
time appears in the display.
3. Press the Start/Pause pad. The delay time will
start counting down.
4. To cancel a delay, press Start/Pause and
reselect the cycle.
Child Lock
The washer controls can be locked to prevent
unwanted use by children.
1. Press the Chime and Delay
Start pads at the same time for
three seconds.
2. The Child Lock light will
illuminate.
3. To unlock, press the Chime and Delay Start pads
at the same time for three seconds. The Child
Lock light will go out.
STEP 6
Cycles, options, lights
Wha t can & cannot b e
washed
oper ati ng tips
dishwasher use
loading
Controls a t a glance
Dryer Exhaust tips
Saf ety
Car e & Cleaning
Ser vice & Warran ty
Surfac e Co oking
troublesho oting
Oven Co oking
Sto rin g the washer
Installa tion
Special Fea tures
Notes
Using the Controls
STEP 7
Start the Washer
To start the washer, press the
Start/Pause Pad.
Changing a Cycle
If an incorrect cycle has been accidentally selected:
1. Press the Start/Pause pad.
2. Turn the Cycle selector dial to the
desired cycle.
3. Set the desired options for the cycle.
4. Press the Start/Pause pad. The Wash indicator
lights stops flashing and the new cycle starts.
Canceling a Cycle
To cancel a cycle:
1. Press the Power Off pad.
2. Turn the Cycle selector dial to Drain or Spin.
3. Press the Start/Pause pad. The Spin light
illuminates and the washer starts the drain or
spin.
Cycle Indicator Lights
The Wash, Rinse and Spin lights at the top of the
control panel will illuminate progressively to indicate
when the washer is in those portions of the cycle.
The Washer light will flash when the cycle has been
paused.