Troubleshooting, Warning – Maytag W10234648A User Manual

Page 10

Advertising
background image

10

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

www.maytag.com

Nothing will operate

Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.

Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.

Is the main or regulator gas shutoff valve in the off
position?
See Installation Instructions.

Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.

Surface burners will not operate

Is the oven in self-clean?
Surface burners will not operate during self-clean cycle.

Is the control knob set correctly?
Push in knob before turning to a setting.

Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air from
the gas lines.

Are the burner ports clogged?
See “Sealed Surface Burners” section.

Surface burner flames are uneven, yellow and/or noisy

Are the burner ports clogged?
See “Sealed Surface Burners” section.

On models with caps, are the burner caps positioned
properly?
See “Sealed Surface Burners” section.

Is propane gas being used?
The range may have been converted improperly. Contact a
service technician or see cover for contact information.

Surface burner makes popping noises

Is the burner wet?
Let it dry.

Gas range noises during Bake and Broil operations

Noises that may be heard during the Bake and Broil operations:
Whooshing, Poof, Clicking, Snaps, Pop
These sounds are normal operational noises that can be heard
each time the Bake or Broil burners ignite during the cycle.

A pop can be heard when the gas valve is opening or cycling
on and will make a single pop when it snaps open from the
solenoid. It sounds similar to a suction cup being pulled off of a
piece of glass.

The igniters will click several times until the flame is detected.
These are short clicking sounds like tapping a nail onto a piece
of glass.

A whooshing or poof sound is heard when the Bake or Broil
burner ignites.

On some models, a clicking sound can be heard when the
convection fan relay cycles on and off.

Excessive heat around cookware on cooktop

Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.

Cooktop cooking results not what expected

Is the proper cookware being used?
Ideal cookware should have a flat bottom, straight sides and a
well fitting lid, and the material should be of a medium to heavy
thickness.

Is the control knob set to the proper heat level?
See “Cooktop Use” section.

Is the range level?
Level the range. See the Installation Instructions.

Oven will not operate

Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air from
the gas lines.

Is the electronic oven control set correctly?
See “Electronic Oven Controls” section.

Oven burner flames are yellow or noisy

Is propane gas being used?
The range may have been converted improperly. Contact a
service technician or see cover for contact information.

Oven temperature too high or too low

Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section of the “Electronic
Oven Controls” section.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

Advertising
This manual is related to the following products: