Miele F 9212 i - Manual (Page 34)

Building in the appliance
^ Remove cover a.
^ Secure bracket b with screws c
(4.8 x 16 mm).
^ Push the appliance into the
building-in niche, leaving a gap of
approx. 4 mm.
Take care not to trap the mains
cable.
^ Push in the appliance until the front
edges of bracket b and hinge plates
d and e are flush with the front
edge of the housing.
^ Align the appliance height from above
on both sides using adjusting screw
f.
^ Plug the gap between the appliance
and the furniture wall on the door
opening side with sealing strip
g.
Press the sealing strip into the gap
starting at the bottom, and cut to
length so that it fits snugly to the
lower edge of bracket
b.
Building in the appliance
34