MITSUBISHI ELECTRIC WD-73827 - Manual (Page 94)

94 Chapter 7. Using the TV with a PC
Adjusting Image Resolution
Figure 4
Your Mitsubishi TV can display resolutions from standard
VGA (640 x 480) through XGA (1024 x 768) at 60-Hz
refresh rates. Models WD-62927 and WD-73927
additionally support 1920 x 1080 signals on the 15-pin
PC INPUT. See Appendix A in this book for more on
compatible screen resolutions. The instructions below
are for setting the resolution on most PCs.
1. In the PC’s Start menu, select Settings.
2. Select Control Panel.
3. Select Display.
4. Choose the Settings tab.
5. Change the resolution to the highest resolution with
the aspect ratio best suited for the image. See the
table on the next page showing possible PC formats.
Depending on your PC, adjust the resolution with
either:
• the Screen area slider.
• the Screen Resolution slider
You may need to restart the PC for this change to take
effect.
Hint: Whenever the TV is powered on, the lamp is
in use, even if the TV screen appears dark. As a
reminder that the TV is powered on and that time
is being added to the lamp’s elapsed hours, set the
computer’s screen saver to a pattern that will display
after several minutes of inactivity.
1.
2. 3.
4.
5.
Figure 4. PC resolution XGA selection
Adjusting Image Resolution