Marantz CD5000 - Manual (Page 10)

ADDITIONAL FUNCTIONS
10
You can select a number of tracks and store these in the
memory in the desired sequence. You can store any track
more than once. At most, 30 tracks can be stored in the
memory.
1 Press PROG to start programming.
y PROGRAM flashes.
Note: If you press PROG while playing a CD, the actual track
will be added to the program.
2 Press PREV.
∞ or NEXT § to select the desired track.
or
• Key in the number of a track with the digits 0–9 on the
remote control.
3 Press PROG to store the track number.
y TRACK , TOTAL TIME , and the number of the programmed
track is displayed. The number of programmed tracks is
increased and the time of the track is added to the total
time of the program.
4 Repeat steps 2 and 3 for all tracks to be programmed.
5 Press STOP
9 to end programming.
y PROGRAM lights permamently.
• It is possible to review the program using the PREV. ∞ or
NEXT
§. You can add more tracks by pressing PROGRAM
like you have done before.
6 Press PLAY 2 to start program play.
Note: If you try to store more than 30 tracks
PROGRAM FULL scrolls through the display.
1 If necessary press STOP
9 to stop program playing.
2 Press STOP
9 to clear the program.
y PROGRAM CLEARED scrolls through the display,
PROGRAM disappears and your program is cleared.
Note: The program will also be cleared if you open the tray.
You can search for the loudest passage of a CD or program.
This will help you in adjusting your recording device if
required.
1 If necessary press STOP 9 to stop CD play.
2 Press PEAK to start searching.
y PEAK starts flashing. Searching may need a few
minutes. Then 4 seconds of the loudest passage are
played repeatedly.
• You can interrupt peak play by pressing PAUSE
;. Continue
peak play by pressing PAUSE ; again.
3 Press STOP
9 to stop playing.
or
• Press PLAY
2 to start CD play.
You can display time information which is stored on the CD.
While playing a CD or a program the number and elapsed
time of the actual track, and
TIME are displayed. If the disc
contains CD-Text the display shows CD-Text information (see
“CD-Text”).
• Press TIME several times to display:
y If the disc contains CD-Text, the number and elapsed
time of the actual track, and
TIME are displayed first.
y The number and remaining time of the actual track, and
REM TIME .
y The number of the actual track, the total elapsed time
of the CD, and
TOTAL TIME .
y The number of the actual track, the total remaining time
of the CD, and
TOTAL REM TIME .
Note: If you press TIME when the CD is not playing you may
only display the total time of the CD.
Time display
Loudest passage searching
Clearing the program
Programming track numbers
English
TIME
HIGHLIGHT SHUFFLE FADE
PEAK EDIT PROG
SCROLL
CD TEXT