Memorex MCD4300BT User Manual
Page 9
8
INSTALLATION INSTRUCTIONS (CONTINUED)
Wall Mounting the Unit
1. Use an existing wall mount, like ones found in a kitchen or
drill one as follows: Drill two holes with a vertical distance
between the two marked positions of 83mm as shown in
Figure 1. Drive a screw into each of the holes. Tighten them
to the end of the screw lines, only leaving the smooth part of
the screw head outside the wall.
2. Plug the telephone line cord into the modular wall jack. Insert
the AC Adapter plug into the bottom of the Base unit.
3. Plug the short telephone line cord into the jack in the Base bottom.
4. Hang the Wall Mount adapter onto the screws, then slide it down firmly to fasten
the base securely as shown in Figure 2.
5. Slide the Base unit onto the Wall Mount adapter as shown in Figure 3.
6. Plug the AC adapter to a conveniently located AC outlet having 120V and 60Hz
only.
83mm
Figure 1
Figure 2
Figure 3
Connecting the Headset (Not Supplied)
Insert the headset plug into the Headset jack on the top of the handset. To answer
a call, simply press the TALK button. To end the call, press the TALK button again.
MCD4300BT.2002.O/M.QXD 4/19/02 9:57 AM Page 8