Monessen Hearth LEXINGTON LX32DV - Manual (Page 33)

51D0528 33
LX Series Direct Vent Gas Fireplace FAcING INStALLAtIoN
INStALL FAcING
Figure 48
1. Align the four (4) holes on the facing with the four (4)
holes on the fireplace.
2. Attach facing with four (4) fasteners provided.
N
ot
Ice
your firescreen’s finish has been covered at the factory with a protective
enamel coating and should never be polished, nor should it ever need to
be polished. Instead of polishing, clean with a mild soap solution using a
clean cotton terry cloth, then dry. to remove any stubborn stains from the
glass, use a mild soap solution, followed by a dampened towel (dampened
with clean water only), followed by a dry towel without using soap. Do not
use ammonia or ammonia-based glass cleaner on the firescreen, as these
types of cleaners may damage the finish of your firescreen. Minor finish
scratches and fingerprints can be removed by applying 50/50 vinegar and
water solution before lighting the heater. Any fingerprints left on the facing
will be permanent when heater is lit.
FP2720
LX facing
Decorative Finish
Facings use Finale
Nuts and Studs
Standard Black
Facings use Bolts
Bolts
Facing
FP2720
Figure 48 -
Install Filigree Facing
IMpoRtANt: to open door with decorative
finish facing, lift door up then rotate door
down.