Philips Magnavox MRV640 - Manual (Page 75)

63
5 Confirm with OK .
aThe following message appears on the screen: 'Please enter
channel number'
b The channel number of the TV channel has not yet been assigned to
the 'VCR Plus+ch.'. Using C , D or the number buttons 0..9 on the
remote control, select the corresponding channel number of the TV
channel and confirm with OK .
aThe following message appears on the screen: 'PlusCode
number wrong'
b The PlusCode number is incorrect. Repeat your entry or cancel using
the TIMER button.
b Check the time/date (see 'Setting the time & date' in 'Installing your
DVD recorder').
aThe following message appears on the screen: 'Date does not
match Mon-Fri'
b A daily recording was entered for the wrong day. Daily programming
can only be used for recordings to be made from Monday to Friday.
Problem
Timer
VCR Plus+ system
Date
01/22 Ch.
001 Start
08:30AM End
10:30AM
Rec
Mode
M1
To store
Press OK
AM/PM
Press SELECT
6 The decoded data appears after confirmation. You can go back
and change the data. Select the appropriate field with
C or D .
Change the information with A , B or the number buttons
0..9 .
Change ' AM/PM'
Use the SELECT button to select 'AM' or 'PM' for 'Start' and 'End'.
Changing the recording mode
Select 'RecMode' using C .
Using B or A , select the recording mode 'M1, M2, M2x, M3, M4,
M6, M8'.
Tip
7 If all information is correct, press the OK button. The
information is stored in a TIMER block.
8 To end, press TIMER .
9 Insert a recordable disc in the Recorder.
The disc is checked.
10 Locate on the disc the position where you want to start the
recording.
11 Switch the Recorder off with STANDBY m .
The programmed recording will only function properly when the
DVD
Recorder has been switched off using the
STANDBY m button.
If any of the TIMER blocks are in use, 'TIMER' will light up on the display.
ENGLISH
Programming a recording (TIMER)