Maytag WT-TOD - Manual (Page 6)

5
Clock and Timer
Clock and Timer Control (select models)
NOTE: The display will flash when electrical power is first supplied to the appliance or if there has been a power failure.
To Set the Clock:
1. Press the Clock pad.
•
A beep will sound when the Clock
pad is pressed.
2. Press or press and hold the ▲ or ▼ pad
until the correct time of day appears in
the display.
• Press to change the time in one
minute increments.
•
Press and hold to change the time
in10 minute increments.
To recall the time of day when the timer is
displayed, press the Clock pad.
To Set the Timer:
The timer can be set from one minute (0:01)
up to 12 hours (12:00). The timer does
NOT control the oven.
1. Press the Timer pad.
• A beep will sound when the Timer
pad is pressed.
•
0:00 will appear in the display.
2. Press or press and hold the ▲ or ▼ pad
until the correct time appears in the dis-
play.
•
Press to change the time in one
minute increments.
•
Press and hold to change the time
in 10 minute increments.
•
Timer will start automatically after a
few seconds. The flashing colon indi-
cates that the timer is in use.
•
If the Clock pad is pressed, the
colon will continue to flash to indi-
cate the timer is in use.
3. A beep will sound at one minute (0:01).
4. At the end of the timer operation, 0:00
will appear in the display and three
beeps will sound.
•
One beep will sound every 10
seconds for 10 minutes or until the
timer operation is cancelled.
To Cancel the Timer:
Press the Timer pad and the current time
of day will reappear in the display.
NOTE: When 0:00 is displayed, pressing
either the Timer or Clock pad will also
cancel the timer operation.