Motorola M68HC08 - Manual (Page 113)

User Guide
Application Hardware and Software Configuration
DRM028 — Rev 0 Designer Reference Manual
MOTOROLA User Guide 113
6.4 Application Hardware and Software Configuration
6.4.1 Hardware Configuration
As mentioned, the software can be configured to run on one of the three
hardware and motor platforms:
• High-Voltage Hardware Set Configuration
• Low-Voltage Evaluation Motor Hardware Set Configuration
• Low-Voltage Hardware Set Configuration
The hardware setups are shown in Figure 6-1 , Figure 6-2 , and
Figure 6-3 . These setups are described in following subsections (see
Hardware and Drive Specifications for each platform characteristics).
The supplied controller boards for MC68HC908MR32 (ECCTRMR32)
allows two possibilities for software execution:
1. MMDS Evaluation Board (KITMMDSMR32)
Using a real-time debugger (supplied with the Metrowerks
compiler) the evaluation board is connected to the controller board
(ECCTRMR32) via an emulator connector. This solution is
recommended for software evaluation.
2. Programmed MCU (MC68HC908MR32)
Where a daughter board module, with MC68HC908MR32
processor, is plugged into the controller board (ECCTRMR32)
instead of the emulator cable, the processor must be programmed
in an external programmer. This solution is recommended for final
tests.
Figure 6-1 , Figure 6-2 , and Figure 6-3 show the configuration with
MMDS evaluation board.
NOTE: All the system parts are described in Section 4. Hardware Design .
They can be ordered as a standard products. For the the supply and in
detail document references see
Section 4. Hardware Design .
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..