Mercedes-Benz S 4300 - Manual (Page 197)

196
Controls in detail
Power windows
̈ Switch on ignition.
Opening the windows
̈ Press switch 1 to 4 at the
symbol
k to the resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈ Press switch 1 to 4 at the
symbol
j to the resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈ Press switch 1 to 4 at the
symbol
k past the resistance point
and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈ Press switch 1 to 4 at the
symbol
j past the resistance point
and release.
The corresponding window closes com-
pletely.
i
You can still operate the windows when
the SmartKey is in starter switch
position 0 or has been removed:
ț until the driver’s or front passen-
ger’s door is opened
ț for no more than five minutes
Warning
G
If you press and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.
!
If the upward movement of the window
is blocked during the closing proce-
dure, the window will stop and open
slightly.
Remove the obstruction, press the
switch
j again past the resistance
point and release.
If the window still does not close when
there is no obstruction, then hold the
switch
j down. The side window
will then close without the obstruction
sensor function.