MITSUBISHI ELECTRIC ws-55413 - Manual (Page 25)

24
25
The remote control may return to its initial setting
when the batteries are changed. You may need to
reprogram.
POWER
PAUSE REC
3
6
9
QV
DEVICE
MENU CANCEL
FORMAT
PIP CH
1
7
SQV
4
GUIDE
2
5
8
0
TV MENU
PIP/POP
HOME
MUTE DEVICE CH VOL
REW/REV FF/FWD
PLAY
STOP
EXCH SLEEP
INFO V-CHIP AUDIO VIDEO
PIP DEVICE CONNECT
TV AUDIO
CABLE/DBS/DTV DVD VCR
size AA
batteries
Figure 2. Installing the batteries.
Figure 1. Remote Control Functions.
Operation
Installing the Batteries:
(Figure 2)
1. Remove the remote control’s back cover by gently
pressing the ridged tab in the direction of the arrow
and sliding off the cover.
2. Load the batteries, making sure the polarities (+)
and (-) are correct. For ease of installation, install
the negative (-) side first.
For Best Results from the Remote Control:
Be within 20 feet of the equipment.
Do not press two or more buttons at the same time
unless instructed to.
Do not allow to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicals to clean. Use only a
soft, lightly moistened cloth.
Do not mix new and old batteries.
Do not heat, take apart, or throw batteries into fire.
Use only AA batteries.
Operating the Remote Control:
You can use the remote to control the TV, CABLE/
DBS/DTV, VCR, DVD, and AUDIO products.
Select the product you want to control by moving the
slide switch to the appropriate position. The remote
control has been preset to operate the TV and other
Mitsubishi products. To program the remote control
to operate other products, see Use of the Remote
Control with Other A/V Products, page .
Remote Control Functions: Care and Operation