MITSUBISHI ELECTRIC X100 - Manual (Page 14)

14
Preparing the projector for operation
Orientation of the projector
Picture size can be set by changing the distance between the screen and the projector.
Diagonal size
(inch)
20 "
40 "
60 "
80 "
100 "
120 "
140 "
160 "
180 "
200 "
300 "
Height inches
(inch)
12 "
24 "
36 "
48 "
60 "
72 "
84 "
96 "
108 "
120 "
180 "
Distance from screen (L) /
(inches) (approximate)
Width feet
(inch)
16"
32 "
48 "
64 "
80 "
96 "
112 "
128 "
144 "
160 "
240 "
Screen
Minimum
zoom (max.)
37"
78"
119"
160"
201"
242"
283"
324"
365"
406"
–
Maximum
zoom (min.)
–
59"
91"
122"
154"
185"
217"
248"
280"
311"
468"
Height projected
image (H) / (inches)
(approximate)
1.5"
3.0"
4.5"
6.0"
7.5"
9.0"
10.5"
12.0"
13.5"
15.0"
22.5"
L (between the screen and center of the head of the lens-barrel)
H (height)
screen To find the approximate distance
between the projector and screen:
Multiply the width of the screen
x 1.85
ف 1.95 (max.) ,
Multiply the width of the screen
x 2.33
ف 2.53 (min.) ,
• Refer to the chart to recom-
mended distaces in maximum
zoom and minimum zoom.
Caution:
• Placing the projector on a carpet reduces ventilation from the fan on the bottom and might cause
problems. Place a hard board or similar item under the projector to facilitate ventilation of the
unit.
• Place the projector more than 8 in. from the wall to prevent blocking the intake, exhaust slots and
ventilation of this projector because hot air comes out of it.
• Do not use the projector under the following circumstances, which may cause fire or electric
shock.
• in a dusty or humid place
• while the projector is lying sideways or upside down.
• near a heater
• in a kitchen or oily, smoky or damp place
• in direct sunlight
• where the temperature is lower than 41
°
F or higher than 95
°
F
Important:
• Do not put stress on the lens or focus ring, as this may damage them.
• Keep your room dark while using the projector. The image cannot be seen clearly in a bright place.