Miele W1986 - Manual (Page 44)

Level the washer
To ensure smooth operation, the washer
must be level.
Failure to level the machine can result
in increased water and energy
consumption, loud noise during the
spin cycle or "walking" across the floor
during use.
Adjust the four leveling feet
The washer is leveled by adjusting the
four feet:
^ Tip the machine slightly and place a
support, such as a block of wood,
underneath it.
,
CAUTION: The washer is
extremely heavy. When tipping the
machine, be careful that it does not
slip.
^ Unscrew each of the four feet as
much as necessary by turning both
the foot,
1 , as well as the locking ring,
2 , to the left using a screwdriver.
^ Remove the support and stand the
machine on its feet.
^ Check that the machine stands level.
^ Repeat the above procedure until the
machine stands level.
^ Once level, hold the foot,
1 , immobile
with a wrench. At the same time, turn
the locking ring,
2 , to the right using
a screwdriver.
,
All four locking rings must be
tight against the bottom of the
machine. In addition, check to see
that the feet were not inadvertently
unscrewed while tightening the
rings. Operating a machine that is
not level or whose feet are not tight
may cause damage to both the
machine and its surroundings.
Installation
40