Marmitek MS9770 - Manual (Page 23)

23 MS9470/MS9770/MS9970 ඀
INSTALL – Position for installing sensors and for changing system settings.
RUN 1 – For normal alarm operation.
RUN 2 – For normal alarm operation. When in disarmed mode, the base station will give a pleasant
sounding tone when a door or window is opened (access control).
ARM AWAY: Full activation of the alarm system. All sensors are activated.
ARM HOME: Partially activated alarm. Alarm function when being at home. Only door and window sensors (no motion
sensors) are activated. You can walk around while the outer “shell” of the house is still protected.
A. The ARM AWAY function can be activated in the following three ways:
Press the ARM AWAY button on the SC2800 base station: Single tone confirmation beeps during arming delay (1 minute)
When the system is armed after one minute: ARM indicator comes on
Press the ARM AWAY button on the SH624 system remote control: Depending on the settings of the SC2800 (5.6) the
system will arm instantaneously or delayed. When delayed, the confirmation beep will sound (1 minute)
When the system is armed after one minute: ARM indicator comes on
Press the ARM button on the KR21 key chain remote control: Depending on the settings of the SC2800 (5.6) the system will
arm instantaneously or delayed. When delayed, the confirmation beep will sound (1 minute)
When the system is armed after one minute: ARM indicator comes on
B. The ARM HOME function can be activated in the follow two ways:
Press the ARM HOME button on the SC2800 base station: Depending on the settings of the SC2800 (5.6) the system will
arm instantaneously or delayed. When delayed, the confirmation beep will sound (1 minute)
6. OPERATING THE SYSTEM
6.1 INSTALL, RUN 1 AND RUN 2
6.2 ARMING THE SYSTEM