MTD E665E - Manual (Page 5)

5
SECTION 4: CONTENTS OF HARDWARE PACK
Lay out the hardware according to the illustration for identification purposes. Part numbers are shown in parentheses.
(Hardware pack may contain extra items which are not used on your unit.)
A
ATTACHING THE HANDLES
(2)Hex Bolts (A)
(710-3180)
(4)Lock Washers (C)
(736-0119)
(2) Saddle (I)
(784-5599)
(2) Hex Bolts (B)
710-3008
B
ATTACHING THE HANDLE PANEL
(4) Carriage Bolts (E)
(710-0262)
(4) Hex Nuts (D)
(712-3010)
(4) Lock
Washers (C)
(736-0119)
D
ATTACHING THE CLUTCH CABLES
(2) Hex Nuts (J)
(712-0121)
(2) “Z” Fitting (R)
(746-0778)
E ATTACHING THE CHUTE ASSEMBLY
(6) Hex Lock Nuts (M)
(712-3027)
(6) Hex Bolts (K)
(710-3015)
G AUGER SHEAR BOLTS (SPARES)
(2) Shear Bolts
(710-0890A)
(712-0429)
(2) Hex Lock Nuts
(3) Chute Flange Keepers
(Not Shown) (731-0851)
F
ATTACHING THE CHUTE CRANK ASSEMBLY
Cupped Washer (N)
(736-0242)
(2) Flat Washers
(736-0185)
Hair Pin Clip
(714-0104)
(2) Hex Nuts (D)
(712-3010)
ATTACHING THE SPEED SELECTOR PLATE
AND SHIFT LEVER
C
(2) Hex
Bolts (G)
(712-3015) (2) Hex Lock Nuts (H)
(712-3027)
(4) Self-Tapping
Screws (F)
(710-0599)
Hex lock nuts cannot be threaded onto a bolt by hand. A wrench
is required for assembly. This type of nut is used where vibration
occurs.