MTD E665E User Manual
Page 6
6
SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT:
After assembly, service engine
with gasoline, and check oil level as instructed in
the separate engine manual packed with your unit.
NOTE:
References to right or left side of the snow
thrower are determined from behind the unit in the
operating position.
UNPACKING
• Remove staples or break glue on the top
flaps of the carton. Remove any loose parts
included with unit (i.e., operator’s manual,
etc.).
• Cut along dotted lines and lay end of carton
down flat. Remove packing material.
• Roll unit out of carton. Check carton
thoroughly for loose parts before discarding.
TOOLS REQUIRED FOR ASSEMBLY
• (1) 3/8" or adjustable wrench
• (2) 7/16" or adjustable wrench
• (2) 1/2" or adjustable wrench
LOOSE PARTS IN CARTON
(See Figure 1)
Figure 1
A
(2) Handles (Right and Left)
B
(1) Handle Panel Assembly
C
(1) Speed Selector Plate
D
(1) Shift Lever
E
(1) Chute Crank Assembly
F
(1) Chute Assembly
(1) Hardware Pack
A
C
D
E
F
B