Mr. Coffee SR10 - Manual (Page 8)

Move the CONTROL switch to ON. When coffee stops flowing, the
brewing cycle is complete.
7. Discard the used grounds and filter. Rinse the brewing funnel and slide it
back into place.
Note: The wanner plate on model SRX55 will keep your coffee piping
hot for two hours and then, as a safety feature, the coffeemaker will shut
off automatically. For an additional two hours of keep-warm time, move
the CONTROL switch to ON.
8. To make another pot of coffee, turn the coffeemaker off and repeat steps
#l through #7.
9. Se sure to turn the CONTROL switch when the decanter is empty
and you are no longer using your coffeemaker.
SUGGESTED COFFEE MEASUREMENT CHART
For the best results. use level tablespoons (tbls.) or level coffee scoops of
drip grind recommended for automatic drip coffeemakers.
TO BREW USE THIS MUCH GROUND COFFEE:
10 cups 9 tbls. or
8 Cups 7 tbls. or
6 Cups 6 tbls. or 3
4 cups 5 tbls. or scoops
2 cups 3 or 1
l
Use more or less coffee to suit your taste.
2 level tablespoons 1 level scoop
.
Automatic Shut-Off (Model SRX55)
1. Once your coffeemaker is turned on, the coffee in the decanter will stay
hot for two hours. Then, as a safety feature, the coffeemaker will shut
itself off.
2. To keep your coffee hot for an additional two hours, simply move the
CONTROL switch to OFF and then to ON.
3. Move the CONTROL switch to OFF if you empty the decanter before
the end of the two hour period.
Automatic Pause Serve Drip Stop Valve
For your convenience, our Pause ‘N Serve feature allows you up to
to sneak a cup while the coffee is still brewing. It also prevents any
remaining coffee in the filter basket from dripping onto the warmer plate once
the brew cycle is completed.
TO PREVENT INJURY FROM HOT OVERFLOW, REPLACE DECANTER WITHIN
30
SECONDS, IF REMOVED DURING BREWING.
8