Electrolux EHG30235 x - Manual (Page 74)

74
Once the hob has been installed, it is
important to remove any protective materials,
which were put on in the factory.
Hob burners control knobs
The hob burners control knobs are situated on the hob
right hand side. The symbols on the knobs mean that:
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a
pan on the pan support.
To light a burner:
1. turn the relevant knob anticlockwise to maximum po-
sition ( ) and push down the knob to ignite.
2. After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the "thermocouple"
(Fig. 1, lett. D) to be heated and the safety device to
be switched off, otherwise the gas supply would be
interrupted.
3. Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1, lett. A) and the
"crown" (Fig. 1, lett. B) are in the correct position.
To put the flame out, turn the knob to the "off" position
(symbol )).
• Always turn the flame down or put it out before
taking the pans off the burner.
In the absence of electricity, ignition can occur without
the electrical device; in this case approach the burner
with a flame, push the relevant knob down and turn it anti-
clockwise until it reaches the "maximum" position.
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
Instruction for the User
!
Fig. 1
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
A
B
C
D