Marantz SR4000 - Manual (Page 18)

13
ENGLISH
SOURCE SELECTION
When selecting a source by turning INPUT SELECTOR,
the audio and video inputs with the corresponding name are
activated. The incoming signal is reproduced by all audio and
– if the source includes a video signal – video outputs of the
receiver.
Source selected .........Connectors used
DVD .............................COAX 1 digital audio input and
DVD IN video input
PHONO........................PHONO IN audio input
TUNER ........................The tuner part of the receiver is used,
all inputs are switched off.
CD................................CD IN audio input
CDR/TAPE...................CDR/TAPE IN audio input
TV ................................TV IN audio input and
no video input
VCR .............................VCR IN audio input and
VCR IN video input
SAT..............................SAT IN audio input and
SAT IN video input
The 6 channel input connectors can be assigned to any of the
available sources (excluding TUNER and PHONO). The
assignment can be done via the
option in
the menu.
See below for more details.
If a source is selected with INPUT SELECTOR the standard
audio input is used. To change this, the source selection must
be reassigned to another audio input.
Example: Reassigning from the analogue CD IN audio
input to the digital COAX 2 IN audio input.
1 Choose from the menu and press
NEXT
3.
2 Turn INPUT SELECTOR to select the source which should
be reassigned (e. g. ).
→ The name of the source is displayed and the light of the
source flashes.
3 Turn MENU NAVIGATOR to select the input connectors
which should be used (e. g. ).
4 Press ENTER / OK to confirm your selection.
→
is displayed briefly.
5 This source selection is now using the chosen audio input
(e. g. uses the COAX 2 IN input connectors, C CO OA AX X 22
lights when switching to CD).
You may assign more than one source to a source selection.
This can be useful when products are connected one after
the other in a chain.
Example: A VCR is connected to the TV but only the TV is
connected to the receiver. Both INPUT SELECTOR
settings, TV as well as VCR, have to use the TV
input connectors.
1 Choose from the menu and press
NEXT 3.
2 Turn INPUT SELECTOR to select the source which should
be reassigned (e. g. ).
→
The name of the source is displayed and the light of the
source flashes.
3 Turn MENU NAVIGATOR to select the input connectors
which should be used (e. g. ).
4 Press ENTER / OK to confirm your selection.
→ is displayed briefly.
5 This source selection is now using the chosen audio input (e. g.
uses the TV IN input connectors, is
displayed briefly when switching to VCR).
Using one source selection for two or more
appliances
Reassigning a source selection
6 CH input selection
INPUT SELECTOR