Marantz SR4000 - Manual (Page 19)

14
ENGLISH
PLAYBACK, RECORDING
1 Press POWER ON / OFF to switch on the receiver.
2 Turn INPUT SELECTOR to select a source.
→
The name of the source is displayed.
• You can select the FRONT AV input by pressing FRONT
AV.
3 Start playback of the source as usual.
• Turn VOLUME to adjust the volume.
→ and the volume level between and is
displayed.
1 Press BASS or TREBLE.
→
or and the actual value are displayed
briefly. Then
is scrolled.
2 Turn VOLUME to adjust the bass or treble.
→
or and the actual value are
displayed.
Note : If VOLUME is not turned within 5 seconds or if any
other control is used, the bass or treble adjustment is
switched off.
• Press SOUND on the remote control to scroll through the
built-in smart sounds: , , ,
and . ( is the
userdefined bass and treble setting.)
→
SMART SOUND is displayed and the name of the chosen
sound profile is scrolled once if smart sound is on.
• Press LOUDNESS to switch loudness either on or off.
→
LOUDNESS is displayed if loudness is on.
If you wish to record from a source you must select it with
INPUT SELECTOR. The incoming signal is reproduced by all
audio and – if the source includes a video signal – video
outputs of the receiver. The sound settings do not affect the
recording.
1 Turn INPUT SELECTOR (or press FRONT AV) to select
the source you want to record from.
→
The name of the source is displayed.
2 Prepare the desired recording appliance. It must be
connected to one of the outputs of the receiver.
3 Start recording on the recording appliance.
4 Start the playback of the source as usual.
Notes: – The audio and video signal of VCR IN is not
reproduced by VCR OUT. The same applies to
the audio signal of CDR/TAPE IN to CDR/TAPE
OUT.
– We recommend not to use the digital output
COAX OUT of the receiver to record from an
analogue source. Use the analogue output
CDR/TAPE instead.
It is possible to connect a digital recorder to the digital output of
the receiver. In this way, all signals coming from the digital
inputs can be recorded directly on the connected audio
recorder. The receiver will also convert all signals coming from
the analogue inputs to the digital output.
The receiver can be used to record digitally a multichannel
surround sound audio signal (Dolby Digital) from, for example,
DVD to CD-R. The receiver will convert the digital multichannel
signal into a stereo signal without loss of relevant sound
information.
Notes: – Do not use the 3D SURROUND feature while
making digital recordings as this will distort the
digital audio signal.
– When recording a Dolby Digital signal, each track
must be recorded individually.
Recording from the digital output
Recording from a source
Adjusting the sound
Playing a source