Mattel UCREATE N9496 - Manual (Page 9)

BATTERY INSTALLATION / REPLACEMENT
This game is powered by four (4) AA (LR6) batteries.
• Using a finger press tab back and lift the compartment door.
• Insert four (4) AA (LR6) batteries as indicated inside the battery compartment.
• Replace the battery compartment door and push until tab snaps into place.
• Batteries included are for demonstration purposes only.
• For longer life use only alkaline batteries.
• Replace the batteries when the product does not function properly or you receive a warning from
the low battery indicator.
• Remove batteries and dispose of them safely.
ADULT SUPERVISION IS RECOMMENDED WHEN CHANGING BATTERIES.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin
your product. To avoid battery leakage:
• Do not use rechargeable batteries.
• Non-rechargeable batteries are not to be recharged.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of batteries safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
CAUTION
• Sometimes, a build-up of static electricity (from carpets, etc) may cause the game to stop
working. Just reset the game, and it will work again.
• In an environment with radio frequency interference, the product may malfunction and
require user to reset the product.
• The unit may malfunction when there is radio interference on the power line and signal
line. The unit will revert to normal operation when the interference stops.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio / TV technician for help.
Keep these instructions for future reference as they contain important information.
14 15