Mark Levinson N390S - Manual (Page 38)

38
Basic Operation
Before operating your Nº390S, take a minute to become familiar
with its controls and their locations. (See “Front Panel, Nº390S”
and “Remote Control, Nº390S.”)
Loading a CD To load a CD:
1. Make sure that the main power switch is set to the “|” position.
2. Press stop/drawer to open the drawer.
3. Place a CD into the recess of the drawer, label side up. Handle
the CD by the outer edges and center hole only.
4. Press stop/drawer.
Note: If you have previously saved a program for the CD, the letter
P
will appear preceding the track number on the display. (See
“Programming the Nº390S.”)
To override a previously saved program, briefly press mode – once while
in program mode. All of the CD’s tracks will be accessible for basic
operation, but the program will still be retained in the Nº390S’s memory.
Playing a CD To play all tracks on the CD, press the play button. All tracks will
play in order. Play will stop automatically at the end of the CD.
To begin play with a track other than the first track:
1. Before pressing play, press next until the number of the
desired track shows on the Display. If you pass the track you
want to play, you can “back up” by pressing previous. (You
may also select the track using the numbered buttons on the
Remote Control.)
2. Press play to begin playing that track. The remaining tracks will
play in order. Play will stop automatically at the end of the CD.
To return to the beginning of a track while it is playing, press
play
. Play will be suspended briefly, then that track will replay
followed by the remaining tracks on the CD.
Random Play Using the Remote Control, you may have the Nº390S play tracks
at random. To do this, press the 0 (zero) numbered key, then press
play
. The display will show RANDOM briefly to indicate that you
have entered the random-play mode. Subsequently, the letter R
will appear preceding the track number in the display as a
reminder. To cancel random play, press stop.