Mark Levinson N390S - Manual (Page 59)

59
Specifications
The correlation between published specifications and sonic quality is
unreliable. A list of numbers reveals virtually nothing. All technical
measurements must be subject to qualitative as well as quantitative
interpretation.
Measurements of the Nº390S yield excellent results by any standards.
However, only those specifications that apply to its actual operation are
included here.
Frequency Response • 10Hz - 20kHz, +0dB, –0.3dB
Total Harmonic Distortion • 0.002% @ 1 kHz, 0dBFS (10Hz-30kHz)
(THD)
Dynamic Range • 96dB (10Hz-30kHz)
Signal-to-Noise Ratio • 105dB (10Hz-30kHz)
Channel Separation • Better than 110 Db
Intermodulation Distortion • Less than 0.005%
(SMPTE IMD)
Maximum Output • 4.45V balanced
(0 dBFS signal) • 2.225V single-ended
Volume Control • –61.2 to +12 dB
(attenuation) Range
Digital-to-Analog • Dual differential 24-bit DACs
Conversion
Conversion Rate • 352.8kHz or 384kHz(input signal dependent), 24-bit
Analog Filter • Bessel-tuned, linear phase to 40kHz
Low-level Linearity • deviation less than 2 dB to below –90Dbfs less than 2 dB to
below –102dBFS w/20-bit input
Output Impedance (analog) • 10
Ω
Direct Digital Output, XLR • AES/EBU 110
Ω
, 3.5V
Direct Digital Output, RCA • S/PDIF 75
Ω
, 0.5V
Mains Voltage • 100V, 120V, 200V, 220V, 240V, factory set for destination country
Mains Frequency • 50 or 60 Hz, factory set for destination country
Power Consumption • 36 watts maximum
Overall Dimensions • See “Dimensions”
Shipping Weight • 50 lbs. (23 kg)
Input Complement • 1 EIAJ digital input
• 1 S/PDIF (RCA) digital input