Milan Technology MIL-195C - Manual (Page 2)

2
Installation Guide MIL-185C/MIL-195C
7
About this Manual
This manual covers both the MIL-185C and the MIL-195C
media
converters.
The terms “converter” or “device” are used throughout
the document to describe either the MIL-185C or the
MIL-195C.
Introduction
The MIL-185C and the MIL-195C are compact, physical
media converters that allow the user to convert signals
between ATM fiber optic cabling in either multi-mode or
single-mode, and UTP cabling. Both converters support
OC-3 (155Mbps) speeds.
Features
• Fiber budget sufficient to drive 2 km for multi-mode
or 15 km for single-mode fiber
• One SC-type single-mode (MIL-195C) or one SC-type
multi-mode (MIL-185C) connector
• One shielded RJ-45 UTP connector
• External power supply
• Diagnostic LEDs
• Small form factor
Operating Conditions
Table 1: Recommended Operation Conditions
Parameters Minimum Maximum
Operating Temperature +5° C 40° C
Humidity: non-condensing 10% 95%
Signal Output Load 35 ohm 75 ohm
Supply Voltage 4.75 V 5.25 V
Power Supply
External power is required. The device draws 900 mA at
normal operation in room temperature of 25° C.
• Domestic: 110 V AC wall mount power supply.
• International: 220 V AC power supply with IEC
receptacle.
Connectors
1 2 3 4 5 6 7 8
Figure 5. RJ-45 Connector
RJ-45 Pinouts
• Pin 1 = Transmit Data +
• Pin 2 = Transmit Data -
• Pin 7 = Receive Data +
• Pin 8 = Receive Data -