Chapter 2: network planning, Introduction to switching, Application examples – MRV Communications MR2228-S2C User Manual

Page 12

Advertising
background image

8

Chapter 2: Network Planning

Introduction to Switching

A network switch allows simultaneous transmission of multiple packets via
non-crossbar switching. This means that it can partition a network more efficiently
than bridges or routers. The switch has, therefore, been recognized as one of the
most important building blocks for today’s networking technology.

When performance bottlenecks are caused by congestion at the network access
point (such as the network card for a high-volume file server), the device
experiencing congestion (server, power user, or hub) can be attached directly to a
switched port. And, by using full-duplex mode, the bandwidth of the dedicated
segment can be doubled to maximize throughput.

When networks are based on repeater (hub) technology, the maximum distance
between end stations is limited. For Ethernet, there may be up to four hubs
between any pair of stations; for Fast Ethernet, the maximum is two. This is
known as the hop count. However, a switch turns the hop count back to zero. So
subdividing the network into smaller and more manageable segments, and linking
them to the larger network by means of a switch, removes this limitation. A switch
can be easily configured in any Ethernet, Fast Ethernet, or Gigabit Ethernet
network to significantly boost bandwidth while using conventional cabling and
network cards.

Application Examples

The MR2228-S2C is not only designed to segment your network, but also to
provide a wide range of options in setting up network connections. Some typical
applications are described below.

Collapsed Backbone

The MR2228-S2C is an excellent choice for mixed Ethernet and Fast Ethernet
installations where significant growth is expected in the near future. You can
easily build on this basic configuration, adding direct full-duplex connections to
workstations or servers. When the time comes for further expansion, just connect
to another hub or switch using one of the Fast Ethernet or Gigabit Ethernet ports
built into the front panel, or using a Gigabit Ethernet port on a plug-in SFP

Advertising