Miele KFN 14943 SDE ED - Manual (Page 58)

^ Remove the cover d.
Now the soft-close mechanism and the
appliance are no longer connected.
^ Remove the panel a.
^ Push the shock absorber arm f as
far as possible towards the handle
side.
^ Loosen the three screws g on the
soft-close mechanism and the
spacer.
^ In the middle, pry out the housing
with the soft-close mechanism using
a flathead screwdriver.
^ Then, pry the housing with the
soft-close mechanism out of the
retainer from the appliance side.
^ Lay the soft-close mechanism aside.
^ Push out the spacer towards the
hinge side.
^ Lay the spacer aside.
Removing the top door of the
appliance:
^ Loosen the cover h by carefully
sliding a flathead screwdriver from
below into the recess.
^ Remove the cover h together with
the mounting bracket
i.
^ Loosen the mounting bracket i from
the cover
h by pushing it slightly to
the left and then removing the cover
plate towards the front.
^ Turn the mounting bracket i 180°.
^ Place the cover h onto the front of
the mounting bracket
i and push it
to the right. The writing must be
visible.
^ Unscrew the bearing j mechanism,
turn it 180° and replace it on the
opposite side. If necessary,
pre-punch the screw holes.
^ Remove the top cover k by pushing
it from back to front and lifting it up.
^ Remove the cover l upwards.
Changing the door hinging
58